AIR Non-Linear Reverb

For more information, see the following topics:

Non-Linear Reverb Reverb Section Controls

Non Linear Reverb EQ Section Controls

AIR Non-Linear Reverb is an RTAS plug-in. Use the Non-Linear Reverb plug-in to apply special gated or reversed Reverb effects to the audio signal, creating a synthetic, processed ambience.

 

Non-Linear Reverb plug-in window

Reverse

The Reverse button turns Reverse mode on and off. In Reverse mode, the tail of the reverb signal fades up to full volume, then disappears, rather than fading out.

Pre-Delay

The Pre-Delay control determines the amount of time that elapses between the original audio event and the onset of reverberation.

Dry Delay

The Dry Delay control applies a specified amount of delay to the dry portion of the signal, which can create a “reverse reverb” effect, where the reverb tail is heard before the dry signal.

Reverb Time

Adjust the Reverb Time to change the length of the reverberation’s decay.

Mix

The Mix control lets you adjust the Mix between the “wet” (processed) and “dry” (unprocessed) signal. 0% is all dry, and 100% is all wet, while 50% is an equal mix of both.